Chamber Temp#99

Show Chamber temp if equiped with a sensor with the Nozzle and Bed Temps.

+1 for adding support for extra temperature sensors either for Chamber (or Room) temperature.

Please! I need this supported for my Octoprint and Mailsail 3D printers that have heated chambers.

This is actually causing problems with the Simplyprint Profile not passing along the “Heated Chamber” property to Octoprint: “Not sending “M141 S28”, printer profile has no heated chamber. Either configure a heated chamber or remove chamber commands from your GCODE.”

We should pass this, @atmeng. That’s why it’s in the printer settings - for OctoPrint sync. Is it not working for ya’?

It’s just the error that Octoprint returns. I’m using RepRap gcode output on Orcaslicer for a Duet3 printer: VisionMiner 22 IDEX v3.
I do not get the same error on a Klipper printer with also a heated chamber: Creatbot D1000 HS.