Add AMS 2 Pro filament drying support#440

The AMS 2 Pro with its filament drying, has been a fantastic addition to our print farm. It would be greatly appreciated if SimplyPrint could support the filament drying feature as well.
Some ideas:

• Automatically drying filament when humidity reaches a certain level
• Drying filament when the printer is idle
  Etc.

Additionally, showing the current humidity level in SimplyPrint would be huge. These filament drying settings could potentially be applied to other filament dryers in the future aswell.

Thank you for your time.

I second this.

The ams pro does not support drying while printing.
Which is also not realy needed because even though they added this feature in 2.5.0 for the H2D only, it is limited because it can cause other problems.

What is needed (at least for me) is that “between prints”, enable a feature to automatically heat and use the electromagnetic air exhaust to get the filament back to perfect status, ready for the next print.
If a next print starts, this can stop again no problem.

If we can e.g. set a preferred temp per “print group” e.g. 50C, and a enable/disable idle filament drying on the same level, this would be huge!

For my PLA group I would use other values then my PA6 group.

Second this functionality to be able to setup remote drying for AMS 2 Pro and AMS HT. Would be an unreal addition if possible to setup automated drying cycles or set detection ranges to keep all filament within a set humidity range. Even just having access to start the drying via API we could then control this feature ourselves?